Liber Pigmenta Liber Pigmenta

Посібники з фарбування / Warhammer 40,000 / Death Guard / Blightlord Terminators

Як фарбувати Blightlord Terminators

Референсні фото, колірні схеми з точними фарбами для кожної зони та готові моделі інших малярів — усе, що потрібно, щоб узятися за Blightlord Terminators для вашого війська Death Guard.

Роль InfantryОчки 115Фракція Death GuardСистема Warhammer 40,000

ChaosNurgleBlightlord TerminatorsTerminator

Знайти фарбу

Кожна фарба нижче веде до її відповідників в інших брендах.

Як виглядає Blightlord Terminators

Колірні схеми

Death Guard — Blightlord Terminators

Середній · 5 зон

Plague Marine colours on far bigger plates, so the rust needs planning rather than scattering — decide where water would run before you stipple.

Plague armour

  1. Basecoat the armour Basecoat — Death Guard Green over black. Uneven coverage is a feature here — it reads as grime.
  2. Shade the whole plate All-over shade — Athonian Camoshade across everything. Unlike a clean marine, Death Guard wants the wash on the flats too.
  3. Edge highlight sparingly Edge highlight — Nurgling Green on the plate edges, broken and interrupted rather than a continuous line.

Rusted metal

  1. Basecoat the metal Basecoat
  2. Corrode it Stipple — Typhus Corrosion stippled on unevenly — this is the single step that makes the army look like Death Guard.
  3. Rust bloom Drybrush — Ryza Rust over the wet-looking Typhus Corrosion, concentrated at bolts and joins.

Tarnished bronze

  1. Basecoat the bronze trim Basecoat
  2. Verdigris the recesses Recess shade — Agrax Earthshade first, then Nihilakh Oxide dabbed only where water would sit.
  3. Highlight the bronze Edge highlight

Rotted flesh

  1. Basecoat the flesh Basecoat — Rakarth Flesh over the whole exposed area — pallid, not pink.
  2. Shade and bruise All-over shade — Reikland Fleshshade overall, then Druchii Violet only where the flesh is distended.
  3. Highlight and open the wounds Layer — Pallid Wych Flesh on the raised skin, Bugman’s Glow inside the splits.

Blighted base

  1. Mud the base Texture — Stirland Mud thickly around the feet, thinner at the rim.
  2. Pool the slime Detail — Nurgle's Rot in the low spots only — it is a gloss, so a little reads as standing filth and a lot reads as varnish.
  3. Rim the base Detail

Усі фарби на цій сторінці

18 фарб по всіх схемах і туторіалах вище. Позначте те, що вам потрібно, щоб скласти список, або перейдіть до фарби, щоб знайти її в іншому бренді.

Більше посібників з фарбування Death Guard →

Ведіть цей проєкт від литника до готової моделі

Додайте Blightlord Terminators до своєї купи, позначте фарби, які у вас уже є, і подивіться, чого ще бракує, перш ніж відкривати коробку.

Додати до купи — без акаунта

Згенерувати кольорову схему — без акаунта

Фарб у вашому списку: 0 Зберегти цей список