Liber Pigmenta Liber Pigmenta

Painting guides / Warhammer 40,000 / Ultramarines / Intercessor Squad

How to paint Intercessor Squad

Reference photos, colour schemes with the exact paints for every area, and finished models from other painters — everything you need to start Intercessor Squad for your Ultramarines force.

Role BattlelinePoints 80Faction UltramarinesSystem Warhammer 40,000

InfantryGrenadesImperiumTacticusIntercessor Squad

Find a paint

Every paint below links to its equivalents in other brands.

What Intercessor Squad looks like

Intercessor Squad reference photo

Colour schemes

Ultramarines — Intercessor Squad

Beginner · 6 areas

The squad most painters start with, and the one that sets the standard for everything after it. Batch-paint the five as one model. Painted in Ultramarines colours, from primer to based.

Power armour

  1. Basecoat the armour plates Basecoat — Two thin coats, leaving the recesses slightly darker. Thin with water until the paint flows off the brush rather than sits on it.
  2. Shade the recesses Recess shade — Run the shade into panel lines and around raised details only. A full wash over the plates flattens the armour.
  3. Edge highlight the plates Edge highlight — A fine line along the top edge of each plate, where light would land. Stop before the line meets the next edge.

Bolter and metal

  1. Basecoat the metal Basecoat — Leadbelcher over the bolter body, barrel and any exposed pistons.
  2. Shade the metal All-over shade — Nuln Oil across the whole weapon — metallics are the one area that wants a full wash.
  3. Bring back the edges Edge highlight — Ironbreaker on the barrel rim and casing edges, then a spot of gold on the ammo feed.

Shoulder trim and gold

  1. Basecoat the trim Basecoat — Keep the line clean — trim is what the eye follows, so a wobble here is more visible than one anywhere else.
  2. Shade the trim Recess shade — Agrax Earthshade where the trim meets the plate, so it reads as a separate piece of metal.
  3. Highlight the trim Edge highlight

Helmet lenses

  1. Fill the lens Basecoat — Fill the whole lens recess with the darkest red.
  2. Leave a dark rim Layer — Cover the lens again but stop short of the bottom edge, leaving a crescent of the base colour.
  3. Dot the catchlight Detail — One small dot in the upper corner. The dot is what makes the lens read as glass.

Chapter markings

  1. Block in the right shoulder pad Basecoat — Ultramarines wear a bone pad on the right shoulder. Two thin coats beat one thick one over blue.
  2. Shade and clean up Recess shade — A pin-wash into the pad rim only — flooding the whole pad turns bone into mud.
  3. Highlight the pad and paint the chapter symbol Edge highlight — Screaming Skull on the upper edge, then the omega symbol freehand or transfer.

Base

  1. Texture the base Texture — Astrogranite straight from the pot with an old brush, kept off the rim.
  2. Drybrush the rubble Drybrush — Administratum Grey, then a lighter pass so only the highest grit catches it.
  3. Paint the rim Detail — Abaddon Black around the rim in one steady pass. A clean rim is what makes a squad look finished.

Every paint on this page

19 paints across every scheme and tutorial above. Tick what you need to build a list, or follow a paint through to find it in another brand.

More Ultramarines painting guides →

Track this project from sprue to finished

Add Intercessor Squad to your pile, tick off the paints you already own, and see what is still missing before you open the box.

Add it to your pile — no account needed

0 paints on your list Save this list